Ruggedcom RUGGEDBACKBONE RX5000 Bedienungsanleitung PDF herunterladen (Seite 28)

Chapter 3

Installation

RuggedBackbone™ RX5000

Installation Guide

22 Serial Console Ports

Section 3.4

Serial Console Ports

The serial console port on the CM provides access to the boot-time control and configuration menu interface.

Both the CM serial console port and the one on the front panel of the RX5000 chassis provide a console

interface to the ROX operating system.

The serial ports implement RS232 DCE on a female DB9 connector. Serial settings are: 57600 bps, 8 bits, No

parity, 1 stop bit. The pin assignment of both console ports is given in the Table 4, “Serial Console Pinout” table.

Figure 25: Serial Console Port

Table 4: Serial Console Pinout

Pin Function

DCD (DCD, DTR, and DSR

are looped back internally)

2 RX

3 TX

DTR (DCD, DTR, and DSR

are looped back internally)

5 GND

DSR (DCD, DTR, and DSR

looped back internally)

7 RTS (RTS and CTS are looped back internally)

8 CTS (RTS and CTS are looped back internally)

9 NC

Section 3.5

Copper Ethernet Ports

The RuggedBackbone™ RX5000 can be ordered with up to 96 10/100Base-TX ports that allow connection to

standard CAT-5 UTP cable with RJ45 male connectors. All copper Ethernet ports feature auto-negotiation, auto-

polarity, and auto-crossover functions. The female RJ45 connector can accept and take advantage of screened

(commonly known as "shielded") cabling.

Section 3.5.1

RJ45 Twisted-Pair Copper Ports

Female RJ45 connectors are available on LMs that support 10/100Base-T and on LMs and SMs that support

10/100/1000Base-T Ethernet. Their pin assignments are described below.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Keine Kommentare

Ruggedcom RUGGEDBACKBONE RX5000 Bedienungsanleitung Seite 28